iD Slip Maxi Prime - MEDIUM

iD Slip Maxi Prime description

iD Slip Maxi Prime is a non-woven all-in-one brief brought to you by iD.
Very easy to use, it is put in place with readjustable sealing strips. The combination of velcro and sealing strips ensure perfect fixation, even if readjusted time and again.

• For severe urinary and faecal incontinence.
• Suitable for men and women.

The full iD Slip range

To find out which products in our range are best suited to your needs, here is a summary table showing the various absorption products and available sizes:

iD Slip
Plus S - M - L - XL	Extra S - M - L - XL	Extra Plus S - M	Super XS - S - M - L - XL	Maxi S - M - L - XL	Maxi Prime M - L

iD Slip Maxi Prime application technique

In standing up position

1. Fold the protection in two lengthwise, keep your fingers on the non-woven part and move them around to straighten the leakage barriers.
2. Then move the protection between the legs from front to back as you fold out the far ends, whilst making sure that the upper tip is positioned on the tail bone. Make sure that the protection is correctly centered going by the urine indicators as a guide.
3. Next, fasten the sealing strips from the bottom up to make sure they properly hold around the legs. Then position the sealing strips from the top in order to adjust the protection around the waist.
4. Finally, adjust for optimum comfort. Make sure the velcros are properly fastened. Both the top and the bottom of the sealing strips can be fastened either in an angular or a linear position. They can also be resealed and readjusted if necessary.

In suspine position

1. Fold the protection in two lengthwise, keep your fingers on the non-woven part and move them around to straighten the leakage barriers.
2. Gently turn the wearer on his side, in a safe position (slightly folding the upper leg to prevent him/her from falling out of the bed), out the protection around the back of the wearer whilst making sure that the top of the pad sits on the base of the buttock crease.
3. Return the wearer on his back and pull up the product between the legs whilst making sure the leakage barriers remain activated, then adjust the front part of the protection. If necessary, turn the wearer on his side again to make sure that the rear part of the protection and the sealing strips are correctly positioned.
4. Next, fasten the sealing strips from the bottom so as to ensure the protection properly holds around the legs. Then, fasten the sealing strips from the top in a horizontal position to make sure the protection properly holds around the waist. Check the comfort and the fit (the sealing strips can be repositioned). Make sure that the sealing strips are correctly fastened.

If the self-adhesive fasteners need to be stuck beyond the second strip on the Tape Landing Zone, this means the protection is too big and you need to go for a smaller size.
If the size is too big this increases the risk of leakage!

iD Slip Maxi Prime Characteristics

	iD Slip Maxi Prime Medium
Hip Size	From 80 to 125 cm
Number of pieces per pack	15 Pieces
Number of packs per carton	3 packs
Reference	56302100150
Pack colour	Red
Number of drops